Fluidised Bed Cleaning System

Dies, Filter Vessels, Extruder Screws, Melt line Hardware etc., Suitable for -PP, PET, PA/Nylon, HDPE, Any Plastic Derivative & Paints. Custom built sizes (cylindrical or rectangular vessels) & systems configuration at no extra cost.

Highly efficient cleaning process having excellent heat transfer properties similar to a liquid bath by the application of fluid bed principals for safe cleaning of assembled

tooling with no danger of potential damage to the hardware.

Generates no solid waste & is energy efficient. Being indirect heated (by clamp on ceramic band heaters) provides safety against spot burning, etc., leading to total control over combustion process, offering safe & uniform temperature environments.

The uniform grain size alumina oxide media particles- non toxic-non flammable – chemically & physically inert does not melt or degrade, offer high usable temperature value, reusability over & over again due to infinite life. Minimal operating cost due to low consumables and flexibility to switch-off the system when not in use, making it a low energy & economic operation.

Employees pyrolysis process at a highly controlled rate, decomposes and burns most of the polymer converting it in to off-gas and remaining carbon residue gets converted to Co, within the bed which is exhausted/sucked out by the blower before the cleaning process is completed.

Complete with Unit mounted control Panel (offer precise temperature control through PID controller and smooth Thyrister/S.S.R. Heater Control), Damper -T, Cyclone Separator, Exhaust Blower, First Charge of specially formulated Cleaning Media & Multi tier Loading Grid.

OPTIONAL High efficiency Water Scrubbers or After Burner Units for exhaust gases emission control & Essential Spares for two years trouble free operation.

Operating Temperature approx 450° C depending on the polymer, Utilities Compressed air supply at 4-8 Kg /Cm’ pressure, free of moisture & oil.

380/400/415/440 V Three Phase, 50/60 Hz Power supply.